Internet video: Step-by-step shower fixture installation instructions
Description
Vocal Characteristics
Language
EnglishVoice Age
Young Adult (18-35)Accents
North American (General)Transcript
Note: Transcripts are generated using speech recognition software and may contain errors.
the following videos are intended as supplements. Before beginning the installations, read the installation and care instructions packed with each component carefully for important safety information, required tools and materials and detailed installation instructions. First, we will cover the installation of the push button valve and valve trim for the Kola Real Rain Overhead panel. A separate valve is required in the shower area to control water flow and temperature. Install this valve within arm's reach of the panel inside the shower area. First, determine the desired failed location and route the rough plumbing. Wrap sealing tape on the threads of the inlet pipe if needed. Remove the plaster guard from the valve. Orient the valve so the arrow points in the direction the water will flow, Then thread the valve onto the inlet type, then construct suitable support framing for the valve using to number eight would screw ups. Secure the valve body to support frame. Apply sealant taped to the threats of the outlet pipe. Thread the outlet pipe into the valve. Reinstall the plaster guard to the veil before installing the finished wall capped the outlet. Turn on the water and check all connections for leaks. Once the finished wall is installed, refer to the guard to determine which length screws to use for the installation of the valve Trim, then use a Phillips screwdriver to one. Thread the screw and remove the guard from the valve. Install the leak shield to the valve. Using to screw ups. Read the third screw into the valve stem until it is flush with the front of the leak shield. Verify both plastic bearings are in place, then install the push button. Valve trim comes with both around and a square faceplate. Select the trim desired for your installation. Fifth, the faceplate over the leak shield, then rotated clockwise into place. Ensure the push button is not loose. If the button is loose, remove the faceplate and button and unthreatened the screw as necessary until the button is no longer loose. Next, we will cover the installation of the bracket for the colder, real rain overhead panel. A drop ceiling is required in the shower area where this product is to be installed. Refer to the Installation Guide for detailed instructions on constructing the drop ceiling. This video will show one possible ceiling configuration. Adapt the instructions to fit your specific application. This product is designed for ceiling mount installation on Lee for installations to concrete or solid ceilings. Use anchors to secure all supports to begin used to by force to build support framing to mount the bracket. Mount the support framing. So what his level if possible. Kohler company recommends mounting the two by fours. Flush with the face of the ceiling, Joyce dry fit the bracket to the support so the edges are parallel to the shower wall. Orient the inlet pipe hole so the water supply could be easily connected. Mark the location of the bracket. Connect the 3/8 inch panel inlet pipe to a drop your elbow, then connect the water supply. Secure the drop your elbow, then install the bracket by securing each corner of the bracket with at least two number 81 and 1/2 inch screws per corner. Any two of the four holes in each corner can be used. Finally, Bieber and clean the inlet pipe. This will prevent any damage to the water inlet gasket when the shower unit is installed up. Next, we will cover the installation of the colder, real rain overhead panel, a drop ceiling is required in the shower area where this product is to be installed. This product has a day lose function that requires a manual valve or D TV plus installed within an arm's reach of the panel inside the shower area.