Assembly Guide Narration Video
Description
Vocal Characteristics
Language
EnglishVoice Age
Middle Aged (35-54)Accents
North American (General) North American (US General American - GenAM) North American (US Midwest- Chicago, Great Lakes)Transcript
Note: Transcripts are generated using speech recognition software and may contain errors.
Step three Assembly. First, you need to m 38 bolts from the extrude er's accessory kit and the 2.5 millimeter Allen wrench. Lower the build plate as much as possible. Hold the extrude er by both sides. Take it out of the accessory sleeve and position it on the extrude er seat with the fan facing forward, align the screw holes and fastened with two short silver bolts. Unscrew the two fan bolds and take out the fan baffle to install. Note. Beside the fan Bolt hole, Locate a small hole. You need to insert the bump of the fan baffle into this hole. Take out in M three by six. Bolt in a 2.5 millimeter Allen wrench to secure the fan baffle onto the extrude er. Finally, screw in the two fan bolts. The next step goes through the installation of the spool holders. Install one on each side to install a spool holder, level it and insert the end into one of the openings turned down the spool holder to make the holder, cling to the back of the printer. Next, like the filament guide to with our shape buckles and insert the other end to the film and intake to avoid filament jams. Always ensure that any filaments school you mount on the Creator pro feeds the bottom of the school towards the top filament mounted on the right spool holder, when viewed from the back, should always unspool clockwise and filament loaded onto the left school holder should always unschooled counterclockwise. Congratulations. You finished the hardware assembly process.